1.   The surface electrostatic spraying, anti-acid coating anti-aging, silicone rubber seal, moisture, high temperature. Dust-proof and                             waterproof to withstand damaging effects of outdoor environments.

      2.  High luminous efficiency， High quality power supply, input voltage 100-240V. The power efficiency is more than 90%, power factor                       greater than 0.98.

      3.  The whole lamp with the powder coating is brighter, without fading and corrosion.

      4.  Impact Resistance, Shock-proof, Without Ultraviolet (UV) and Infrared (IR) Radiation: No filament and glass frames, avoid break of the                    traditional lamp,without harm to the human body.

      5. The unit construction of lamp adopt waterproof and dustproof design, the extra accessories can be install in ceiling mounted and bracket              projection-type. It can meet the indoor and outdoor needs and other different application areas.

 Installation Instruction

  （1）MOUNTING WITH PIPE OF INSTALLATION:

                  STEP1:

                            Feed the luminaire leads through the Stem and attach Stem

                           to luminaire by threading the stem into the threaded hub.

                  STEP2:

                            Assemble the junction box to the Stem by placing one of

                            the conduit nut onto stem.

                  STEP3:

                             Loosen,do not remove,junction box screw and flip junction

                           box cover up.Place the junction box onto the stem.

                  STEP4:

                              Place the second conduit nut on to the stem from inside

                           The junction box and tighten the nut.

                  STEP5:

                              Connect the wires correctly and make sure the good wire

                           protection.

                  STEP6:

                              Sealed by water proof glue between fixture and pole.

       （2）SURFACE OF INSTALLATION:

                  *Make sure that the ceiling can support the weight of the lamp.

                  STEP1:

                          Openings one hole greater than 40-50mm through hole in the

                        ceiling.

                  STEP2:

                          Put the fixture on the ceiling, make four marks according to 4

                        mounting kits, then drill 4 holes for them.

                           STEP3:

                          Connect the wires correctly and make sure the good wire

                        protection.

                 STEP4:

                          Get rubber plugs into the holes, match 4 mounting kits to the

                        Rubber plugs, then fix the fixture on the ceilling by screws.

                        Ensure that no wires are pinched during instalation of luminaire.

                 STEP5:

                           After installation, sealed by waterproof glue between fixture

                           and the mounting surface.

      （3）RECESSED OF INSTALLATION:

                 STEP1:

                        Open a 300 * 200 mm through hole on the ceiling.  

                 STEP2:

                        Use included screws to attach mounting brackets to luminaire.

                 STEP3:

                       The luminaire Recessed canopy,Use screws to attach mounting brackets.

                 STEP4:

                       Connect the wires correctly and make sure the good wire protection.