DG-FL080PB

Slimline LED Flood Light is widely used in shopping mall, exhibition hall, parking lot, playground,gymnasium, billboards, park, sculpture, national green lighting project,building facade and public corridor, stair corridor lighting.

Rated power: 80W

Rated voltage: 90-240 VAC / 50/60Hz

Driver Power factory: ≥0.95

Driver Efficiency: >0.88

LED Type: SMD LED 3030 / SMD LED 5050

CRI: Ra>70

Efficacy: 130-180lm/W

Beam angle:120°

IP Rating: IP65

Installations: Bracket Mount

Product Details
Data Download

DG-FL080PB

1. Ultra slim design, fashion and classic. Full aluminum whole lamp radiator technology, pefect efficiently solve the problem of the led heat dissipation, greatly extend the life of the light source.

2. Innovative G-buckle technology, stop glass detaching, free of screw fixing, elegant appearance, easy to install.

3. Large size aluminum PCB fit die-casting aluminum housing, reflector and heat sink integrated.

4. Stainless waterproof connectors for input cable connection, IP65 waterproof, shock resistant fixture,can be widely used as landscape lighting outdoor for building,villa,bridge, gardens,hotels,museum.

5. Explosion-proof glass, high light transmittance rate and good protect LEDs.

6. The client can choose lumen brightness,CRI and CCT,the maximum luminous efficiency of up to 170lm/W.

DG-FL080PB

Par NO Parameter	DG-FL080PB	DG-FL080NB	DG-FL080WB
Sysem consumption	≤82W	≤82W	≤82W
Color Temperature(CCT)	5000-6500k	4000-4500k	2700-3200k
Luminous Flux	11040 lm	10800 lm	9840 lm
Lumious efficiency	138 LM/W	135 LM/W	123 LM/W
System Efficiency	＞90%	＞90%	＞90%
Beam Angle	120°	120°	120°
LED type	LUXEON 3030 / OTHER	LUXEON 3030 / OTHER	LUXEON 3030 / OTHER
LED QTY	80	80	80
Color Rendering Index(Ra)	＞70	＞70	＞70
Working Temperature	-20 ~ 50 ℃	-20 ~ 50 ℃	-20 ~ 50 ℃
Product Size	355X245X55 mm	355X245X55 mm	355X245X55 mm

DG-FL080PB

Installation(Suspended ceiling installation\Horizontal installation\Vertical installation\Any angle installation)

DG-FL080PB

Step1. Ensure all power disconnected and turn off the power switch.

Step2. According to the dimension of bracket hole,drill the holes on the mounting surface and enable it to support

over 3 times weight of the lamp. Install the expansion screw,then lock the screws.

Step3. Loosen screws,adjust the bracket to appropriate angle and then lock screws.

Step4. Connect the input cables of lamp to power supply mains and wrap up the cables with insulated sleeve.

Step5. Switch on the power, the lamp will light on. Refer to the figure below.

DG-FL080PB

Products

Cases

News

About Us

Contact Us

DG-FL080PB

Contact Us

Message Board